Products : Smart Pipe Chase Housings : Bulldog
Pipe Chase Housing
Model AL 1010-2-4
The Bulldog Pipe Chase Housing is designed for Pipes larger then 1 1/2 inches or have insulation on them that can not be interrupted like low temp refrigeration, steam, solar and dry coolers.
Features:
- Two 4 inch start collars for seals.
- Sigrist Exit Seals can be added for conduits.
- Water Bib. Bibs must be on a BFP and winter draindown.
- Welded Aluminum construction with all stainless hardware.
- Powder Coated.
- Housings and Curbs are available in Stainless Steel. Non stock.
- We can build to your wind load requirements. Non stock.
- We provide a hole for the Electrician to mount a GFCI.
- Lid gasket is protected from the elements.
- Built in skirt to protect the leading edge of the roof.
- All mounting and lid hardware is designed so it dose not penetrate the Housing for additional protection.
- Compress the leading edge of the roof between the housing and the top of the curb with a gasketed bolted connection.
Dimensions for the Bulldog Pipe Chase Housing
Model AL 1010-2-4:
Housing Length 20 1/2 inches
Housing Width 14 1/2 inches
Housing Height (without Curb) 13 1/2 inches
There are three parts to the Height. The lid is 2 inches. The center 8 1/2 inches and the skirt at 3 inches.
Dimensions for Medium Curb Model AL 1012,14
Curb Length 19 1/4 inches
Curb Width 13 1/4 inches
Curb Height (without Housing) 11 1/2 inches
The Curb has a two inch flange out to screw to the roof deck. Screw holes are on 2 inch centers.
Standard Models Avalable.
AL 1012,14 Aluminum Housing and Curb
SS 1012,14 Stainless Housing and Curb
